zybo 보드를 산지 벌써 2년?정도 된 것 같다.
집에서 먼지만 쌓이며 썩히다가 지금부터라도 공부를 시작해보려고 한다...
특징을 대충 정리하자면 아래와 같다.
zybo 아키텍쳐
zybo에 사용된 fpga 스펙
The Zynq 7010 AP SoC offers the following features:
650Mhz dual-core Cortex-A9 processor
DDR3 memory controller with 8 DMA channels
High-bandwidth peripheral controllers: 1G Ethernet, USB 2.0, SDIO
Low-bandwidth peripheral controller: SPI, UART, CAN, I2C
Reprogrammable logic equivalent to Artix-7 FPGA
o 4,400 logic slices, each with four 6-input LUTs and 8 flip-flops
o 240 KB of fast block RAM
o Two clock management tiles, each with a phase-locked loop (PLL) and mixed-mode clock manager (MMCM)
o 80 DSP slices
o Internal clock speeds exceeding 450MHz
o On-chip analog-to-digital converter (XADC)
ZYNQ XC7Z010-1CLG400C
512MB x32 DDR3 w/ 1050Mbps bandwidth
Dual-role (Source/Sink) HDMI port
16-bits per pixel VGA source port
Trimode (1Gbit/100Mbit/10Mbit) Ethernet PHY
MicroSD slot (supports Linux file system)
OTG USB 2.0 PHY (supports host and device)
External EEPROM (programmed with 48-bit globally unique EUI-48/64™ compatible identifier)
Audio codec with headphone out, microphone and line in jacks
128Mb Serial Flash w/ QSPI interface
On-board JTAG programming and UART to USB converter
GPIO: 6 pushbuttons, 4 slide switches, 5 LEDs
Six Pmod ports (1 processor-dedicated, 1 dual analog/digital, 3 high-speed differential, 1 logicdedicated)
zybo 보드사진
